Nad's Charcoal Bead Wax

Ingredients

How to Use

1. Always read the directions before use.
2. Ensure the area is clean, dry and free of oils and moisturisers.
3. Leave the jar to stand in the switched off microwave for 1 minute before taking it out to ensure a better diffusion of heat through the wax. The product is ready when the wax has the consistency of thick honey, without any solid beads. (Always test temperature before applying to the area)
4. Apply the wax in the same direction as the hair growth. Leave a small amount of wax at curling up at the end of the patch to make it easier to remove.
5. Let the wax cool on your skin for approx 30 seconds, until it is still soft and pliable but no longer sticky to touch.
6. Holding skin taut with one hand, grip wax and quickly pull off in the opposite direction of hair growth. Remember to hold skin taut with the other hand and to pull close and parallel to the skin rather than upward into the air.
7. Use the Nad's Post Calming Oil/Wipes to remove any wax residue. Do not attempt to use water. Use baby oil to remove wax residue if you run out of oil/wipes.

For best results read and follow detailed instruction leaflet enclosed in pack.

Warnings and Precautions

• KEEP OUT OF REACH OF CHILDREN.
• Before each use, following the directions for use, first test this product on a small patch of skin in the area you wish to treat. If after 24 hours there is no adverse reaction, proceed with full application.
• Waxing may not be suitable for the elderly or diabetics.
• Do NOT use if you are on any medication which can affect the skin or if undergoing any of the following dermatological treatments: topical retin A, skin peel, dermabrasion or laser resurfacing.
• Do NOT use on sunburnt, dry, flaky, broken or irritated skin; over warts, pimples, moles, wounds or varicose veins, or if you have suffered any adverse reaction to waxes in the past.
• Avoid waxing sensitive/intimate areas just before or during menstruation.
• Do NOT use inside the nose or ears, on nipples or scalp.
• Allow 24 hours before using antiperspirant, soap, perfume or astringent lotion on the treated area.
• It is normal for skin to appear red after waxing. If discomfort or a persistent burning sensation, pain or bruising is experienced, apply a cold compress to the skin. If irritation persists for over 24 hours, seek medical advice.

Post Wax Oil/Wipes

• Conduct a patch test on a small patch of skin in the area you wish to treat. If after 24 hours there is no adverse reaction proceed with full application.
• Avoid contact with eyes. If contact occurs rinse with water. If irritation persists seek medical advice.
• For external use only.

FAQs and Tips for achieving the best hair removal results at home

Have a question about Nad's Charcoal Bead Wax? Let us know!

Nad's Product Reviews

Write a review

Rate this Product

* Required

Rate the product from 1 to 5 stars

1 5 (Excellent)

Enter Word Verification in box below *Captcha